Substitute the Motor Coupler on Your Garments Washer Made by Whirlpool

Okay, so your washer is not going to agitate or spin however you’ll be able to hear the motor is operating. There’s a good likelihood that the motor coupler in your washer has damaged. The motor coupler is used on Whirlpool made direct drive washers and it serves as a substitute for the washer belt. This can be a widespread restore for Kenmore, Whirlpool, Roper and KitchenAid direct drive washers.

First, unplug the washer earlier than you start any restore whirlpool washer repair los angeles. Subsequent, you’ll have to take away the console however there are a number of methods to do that relying in your mannequin. The most typical is to take away the tip caps from either side of the console. Firmly pull ahead on the high of the tip cap till it snaps free. You’ll then see one screw on either side of the console that may have to be eliminated. Pull ahead and flip up the entire console gently and let it relaxation backwards. Subsequent, unplug the lid swap connector harness. There are two cupboard high clips on either side that have to be eliminated subsequent. You will have to make use of a flathead screwdriver and leverage to make this simpler. Pry ahead on the highest clips to snap out and bear in mind the place of those clips for reassembly. Now with the clips eliminated carry the washer lid, attain in and pull the entire cupboard ahead and set it out of the best way.

The pump is held to the motor by two retainer clips. Utilizing the screwdriver, pry these clips free from the pump and take away the pump from the motor positioning it to the left and out of the best way. You do not want to take away the pump from the hoses. Subsequent, take away the motor wiring harness. Utilizing a 1/four” nut driver, take away the screws from the 2 retainer clips that safe the motor to the gear case bracket. Once more, use the screwdriver to take away the 2 motor retainer clips. Pull the motor free and you will notice elements of the motor coupler hooked up to the motor and the gear case.

Set up the brand new motor coupler gently utilizing a rubber mallet and the nut driver. One of many plastic items of the motor coupler will go on the motor and the opposite to the gear case. Then connect the rubber heart piece to the gear case coupler and you might be prepared for reassembly.

Start reassembly by first putting in the decrease motor retaining clip. Subsequent, you’ll have to align the motors plastic coupler piece to the gear circumstances rubber piece as they’ll match collectively. This will likely take a number of tries earlier than you’ll be able to get them to suit collectively as a result of that is very tight. Upon getting the motor in place, snap within the decrease motor retainer clip after which the higher motor retainer clip to safe the motor in place. Reattach the pump and its two clips. Lastly the motor harness may be reconnected.

When reinstalling the cupboard, bear in mind the entrance backside of the cupboard slides below the washer body first, after which the remainder of the cupboard is gently set backwards. The perimeters of the cupboard additionally have to lock into tabs on the washer body so it might take a number of tries to get this positioned appropriately. Reinsert the highest cupboard clips by inserting the tip into the outlet first and firmly pushing down on the entrance of the clip. Lastly, join the lid swap wiring harness, pull the console ahead and screw down.

Leave a Reply

Your email address will not be published. Required fields are marked *